This riding helmet has 51 ventilation holes on the shell and 57 holes on the padding. These holes help the warm air to exit at the top and in the back of the riding helmet.
Flexible brim compliant with European standard.
Adjusting the helmet:
For optimal protection, the helmet should be in close contact with the head without squeezing it. When the harness is properly adjusted the helmet should not slide forward, back, or from side to side.
For optimal support, the harness must go under the throat, like a chinstrap, not over the chin.
This helmet has been designed to completely or partially absorb impacts to the rider's head in the event of a fall or violent impact. When an impact occurs, the helmet and/or the padding can deform or break to absorb the energy of the impact. DAMAGE MAY NOT BE VISIBLE, BUT ANY HELMET THAT HAS SUFFERED AN IMPACT MUST BE REPLACED.
The harmonised standard EN 1384 was repealed in October 2014. Until a new version is issued, in order for them to be sold in Europe, all helmets produced after 4 November 2014 must undergo testing and be CE marked. This mark must be accompanied either by Directive 89/686/EEC, or by the VG1 01.040 2014-12 document.
Information on standards:
EN 1384 certified helmets can still be worn in training and competitions. However, some organizations may require other standards for their competitions. If in doubt, we recommend that you consult the competition organiser.
Wash outer surface with soapy water, rinse, then dry. Wash foam parts at 30°C max. Do not tumble dry.