WATERPROOFING
- 3-layer hydrophilic component.
- >10,000 of water pressure after 5 washes
- 100% taped seams.
- Ankles adjustable by rip-tab strip
- Synthetic rubber strip at the ankles for a lasting waterproof seal.
BREATHABILITY
RET <15: average breathability.
To find out whether a fabric is breathable, we measure its evaporative resistance, or RET, (test based on the ISO 11092 standard). It is its ability to allow the water vapour produced by the body during exercise to escape.
POCKET
The large gusset pocket on the right thigh has a letterbox fastening and a storm cord which allows you to keep your equipment safe.
FEATURES
The waist is adjustable with semi-elasticated rip-tabs. The overtrousers also have an elasticated cord under the chest which adjusts with a toggle to ensure excellent hold.The knee, seat, and heel reinforcements are made of an abrasion- and wear-resistant component. They are equipped with removable articulated foam pads for added protection of the sailor's knees and seat.
HOW TO REACTIVE THE JACKET'S WATER REPELLENCY
step 1: before washing
Close all zips and flaps and remove any parts of the garment that cannot be washed. Also remember to loosen the straps and elastic parts and empty the pockets.
Then turn the garment inside out to wash it.
HOW TO REACTIVE THE JACKET'S WATER REPELLENCY
step 2: washing
You can wash your jacket on a synthetic cycle at 30° or 40°C with your usual detergent. Do not use fabric conditioner, which could damage the existing performance of the garment, or bleach.
Also take care not to bend your jacket too much when you place it in the washing machine and do not overload your machine.
Very important: select a thorough rinse or double rinse to completely remove all detergent residue.
HOW TO REACTIVE THE JACKET'S WATER REPELLENCY
step 3: drying
Drying is a crucial phase in reactivating the water repellent treatment.
We recommend that you lay your jacket flat on a clothes rack and leave it out to dry in the open. Caution: never dry your jacket directly on a radiator.
Then place it in the tumble dryer on a short synthetics cycle, i.e. 10 to 15 minutes, before turning it back the right way round. Caution: do not over-dry the garment.
HOW TO REACTIVE THE JACKET'S WATER REPELLENCY
If, despite this procedure of washing and thorough rinsing followed by gentle drying in a tumble dryer, the drops of water no longer run off the surface of your jacket, we recommend that you "re-waterproof" it using a waterproofing spray.
Tips for storage and maintenance
Machine wash - 30° max - normal
Do not bleach
Tumble dry - low heat
Do not iron
Do not dry-clean
Storage tips
Store in a dry place, but do not leave your garment on a heat source such as a radiator, as this may damage the breathable membrane or coating.
