Men's sailing waterproof windproof jacket SAILING 300 Light grey
Store Availability
Store Availability
BENEFITS
Water repellent
Water beads and runs off the fabric to keep you dry for longerCoverage
Hood (covering and adjustable) can be stored in the collar.Windproof
Windproof membrane, high neck, and adjustable hood with good coverageWaterproof
Moderate rain. Laminated fabric 15,000 Schmerbers | 100% taped seams.Pockets
4 pockets: 2 zipped fleece-lined, 1 chest zipped, 1 inside with rip-tabBreathability
2-layer breathable lining, RET < 9TECHNICAL INFORMATIONS
Features of the 300 jacket
- more waterproof fabric (15,000 Schmerbers)
- rip-tab wrist fastening
- interior flap with a drainage channel
- hood that packs into the collar and can be adjusted in depth
- neon yellow hood (on the grey jacket) so that you are visible
- extra outer chest pocket
Details below
Technical features of the component
- Water-repellent fabric (water runs off the fabric)
- 100% taped seams
Collar and hood
Completely depth and height-adjustable hood: adjustable at the back of hood and on the collar.
The chin-high neck effectively protects the lower part of your face. 9 cm high collar (at the back)
Sleeve protection
To take off the jacket more easily, fully open the rip-tab
Front zip closure
Soft fabric flap at the top of the collar to limit chin irritation.
Injected plastic zip to prevent oxidation by salt
pockets
1 inside chest pocket on the left side to store your phone or other items, fastened with a zip
1 inside chest pocket on the right side fastened by hook and loop
PLEASE NOTE: the pockets are NOT WATERPROOF
Waterproofing 1/2 - the 300 jacket's component
Here are the waterproofing ratings:
Component resistant to water pressure of 5,000 mm after ageing (5 washes). Equates to 15,000 Schmerber (JIS standard), which is the average pressure applied by the water in a shower.
The anorak's waterproofness was tested in a rain shower with 60 litres of water/m²/hour for 2 hours.
Component Breathability
We consider that if:
RET < 9 = very breathable fabric
9 < RET < 12 = breathable fabric.
The Sailing 300 jacket's RET is < 9.
Water-repellent properties information
Your jacket does not become waterlogged and remains lightweight and breathable. The water-repellent properties are achieved with a treatment applied to the external side of the fabric, but in practice these properties can be altered.
The water-repellent properties can be reactivated by putting the jacket in a dryer for 10 minutes at the lowest temperature.
How to wash your jacket?
Close all zips and flaps, stow the hood and then turn the garment inside out to wash it. You can wash it on a synthetic cycle at 30°C or 40°C with your usual detergent. Do not use fabric conditioner, which could damage the existing performance of the garment, or bleach. Very important: choose a full rinse cycle or extra rinse.
How to reactivate the jacket's water repellency
We recommend that you lay your jacket flat on a clothes rack and leave it out to dry in the open. Caution: never dry your jacket directly on a radiator.
Then place them in the tumble dryer on a short synthetics cycle, i.e. 10 to 15 minutes, before turning it back the right way round. Caution: do not over-dry the garment.
composition
composition
Tips for storage and maintenance
TESTS AND WARRANTY
Warranty
Ecodesign approach
With ecodesign, we reduce the environmental impact of our products.
Analysing the product's environmental footprint enabled us to identify the most impactful stages of its life cycle. Thanks to this approach, our design teams were able to develop this product while significantly reducing its environmental impact.
Ecodesign actions on this product
-
Process
Dope dyed
Product made from 6% dope dyed yarn
Using this mass-dyeing process enables us to reduce CO2 emissions linked to the production of dyed textiles by at least 46% compared to conventional dyeing.
-
Process
Dry dyed
Product made from 39% dry-dyed yarn
Using this waterless dyeing process enables us to reduce CO2 emissions linked to the production of the dyed component by at least 43% compared to conventional dyeing.
-
Material
Recycled polyester
Product made from 61% recycled polyester
Using recycled polyester rather than conventional polyester reduces the CO2 emissions linked to the material by at least 16%.