Go to search
Go to content
Go to footer

9.5 mm climbing rope - Zenith 80 metres

A simple, lightweight, easy-to-handle rope ideal for performance on rock faces.

ID 8769209

Sold and shipped by

How to get it

lightweight
A good compromise between weight and strength . 59 g/m
ergonomic grip
Perfect balance between good grip for belaying and a low weight. 9.5 mm
stretch
Absorbs energy extremely well, thanks to its low impact force of 7.5 Kn
abrasion resistance
38% sheath for good durability

Description

Design details

STORING YOUR ROPE
Ropes should be stored in a cool, dry place, away from light, humidity, and corrosive agents. Never leave ropes inside a car during summer, for example.
WASHING YOUR ROPE
It's important to properly care for your rope to reduce wear. As dirt wears ropes down, we recommend: 1- using a rope cover; 2- If the rope is dirty, wash it with clean, lukewarm water. Should stains persist and you want to wash it with soap, it is important to use a pH-neutral soap (such as Marseilles/household soap) and then rinse thoroughly with clean water. 3- Air dry the rope out of the sun and away from all sources of heat.
WEIGHT
59 g/m PLEASE NOTE: Weight measurements made according to the EN 892 standard. For example, for a single rope, the rope must be exposed to 10 kg of tension for 1 minute in very precise temperature and moisture conditions. This gives you the real weight of the rope, which is often superior to the weight given by the standard. The weight measurement according to the standard is used to compare two ropes to each other.
TECHNICAL FEATURES
NUMBER OF FALLS: 6 IMPACT FORCE: 7.5 KN DYNAMIC ELONGATION: 38% STATIC ELONGATION: 9.2% SHEATH SLIPPAGE: 0 NUMBER OF SPINDLES: 48
CERTIFICATION
Rope certified according to standard EN 892:2016 Single
ROPE LENGTH EVOLUTION
As they get older, all climbing ropes get shorter. Usually, they get 2 to 5% shorter, but this can reach up to 10% depending on humidity, heat, falls, washing, etc. To decrease this effect, we calculate an extra margin of length when manufacturing our ropes, but sometimes this isn't enough. This is why we recommend regularly measuring your rope and checking the rope’s middle mark.
CHECKING YOUR ROPE
It is important to check your rope regularly. To do so, run the rope through your hands and inspect it metre by metre along its entire length. This will allow you to spot any nicks, cuts, abrasion or weak points. If you notice any anomalies or irregularities, if the core is visible in certain places, if the rope is deformed or has exceeded its fall rating, it must be changed. Take safety seriously!