DECATHLON

Kids’ waterproof and windproof sailing jacket, 100 navy blue

This kids’ sailing jacket is designed for inshore sailing in wet, stormy and windy conditions.

This waterproof sailing jacket for kids is designed for coastal sailing. Lightweight and breathable, it has a high collar and withstands moderate rain for up to two hours.

ID 8576600

€25.00

Tax included

Colour: Blue

Pick up at Decathlon

loading…
Pick up near you

loading…
Home Delivery

loading…

Features
Design benefits

compact design

This compact jacket can be folded away into one of its pockets

water repellent

Especially treated so water slides off the fabric surface.

windproof

Fabric especially coated to reduce the cooling effect of the wind

waterproof

100% taped seams | 2-layer coating | 5,000 mm Schmerber

pockets

2 closed pockets Non-waterproof pockets

breathability

Very breathable coated fabric (RET < 12): reduces condensation

Design details

The water resistance level

We measure the fabric resistance to water pressure in mm of water column (based on the JIS standard). The higher the water pressure withstood by the fabric, the more waterproof it is.
Here are the waterproofing ratings:
Component resistant to water pressure of 5,000 mm before and after ageing (5 washes). This equates to 5,000 Schmerber average pressure exerted by the water during rain.
The jacket’s waterproofing has been tested in a rain shower with 60 litres of water/m²/hour for hours

Jacket waterproofing

- High collar
- Injection-moulded plastic to avoid salt oxidation
- Water-repellent components (water runs off the fabric)
- 100% taped seams
- Central opening features a flap with a drainage channel for optimal waterproofing

Fabric breathability

To find out whether a fabric is breathable, we test its evaporate resistance or RET (ISO 11092 standard). The lower the fabric’s resistance, the more moisture is evaporated, and therefore the higher the fabric’s breathability.
We consider that if:
RET < 9 = very breathable fabric
9 < RET < 12 = breathable fabric.
The values for the Trek 500 jacket’s breathability are as follows:
> More resistant fabric: RET < 12 (or 3621 g/m²/24 h, JIS1099A standard)
> Lightest fabric: RET < 8 (or 2972 g/m²/2

Hood

The hood does not pack down into the collar, it is attached.
Hood is fully depth-adjustable but not in length. Due to regulations we cannot put an adjustment cord near the neck.
Visor with a headband to provide a good level of protection and a better hold.
The high neck effectively protects the neck.

Pockets

2 zip pockets on the front of the jacket for your hands or a few items
The pockets are not waterproof!

Front zip closure

A zip on the entire jacket length with an interior flap protects against the wind and water.
Soft fabric flap on the top of the collar to protect the chin.

Water-repellent properties information

A fabric is water-repellent when water slides off the surface of the fabric, without seeping in.
Your jacket does not become waterlogged and remains lightweight and breathable. The water-repellent properties are achieved with a treatment applied to the external side of the fabric, but in practice these properties can be altered.

How to wash your jacket

You can wash your jacket on a synthetic cycle at 30° or 40°C with your usual detergent. Do not use fabric conditioner, which could damage the existing performance of the garment, or bleach.

Also take care not to bend your jacket too much when you place it in the washing machine and do not overload your machine.

Very important: select a thorough rinse or double rinse to completely remove all detergent residue.

How to reactivate the jacket’s water repellency

Drying is a crucial phase in reactivating the water repellent treatment.
We recommend that you lay your jacket flat on a clothes rack and leave it out to dry in the open. The radiator? Forget it!
Then place your anorak in the tumble dryer on a short synthetics cycle, i.e. 10 to 15 minutes, before turning it back the right way round. Do not over-dry the garment.
Usage & care
Warranty

2 Years

Care Instructions

Cleaning

DO NOT DRY CLEAN.

DRYING IN TUMBLE DRYER POSSIBLE. LOW TEMPERATURE, MAXIMUM DRUM EXHAUST TEMPERATURE 60°C.

DO NOT IRON.

MAXIMUM WASHING TEMPERATURE 30°C. NORMAL TREATMENT.

BLEACHING EXCLUDED.
Specifications

composition

Upper part - Main fabric: 100.0% Polyamide;Lower part - Main fabric: 100.0% Polyamide;Main lining: 100.0% Silicone;Sleeve lining: 100.0% Silicone;Coating: 100.0% Polyurethane
Environmental impact

With ecodesign, we reduce the environmental impact of our products.

Analysing the product's environmental footprint enabled us to identify the most impactful stages of its life cycle. Thanks to this approach, our design teams were able to develop this product while significantly reducing its environmental impact.
Learn more about our approach

Environmental Impact

Designed to reduce environmental impact

Product made with a CO2eq reduction of 12% compared to the previous or similar product

Read more

Our design teams are working to develop processes that will reduce the impact of a product, while preserving its technical characteristics. This reduction relates to the following indicators: climate change, air pollution, water pollution and resource depletion.