The sleeve is made entirely of 5 mm foam, covered with a "PE 600" type fabric.
To further protect the board, an extra layer of foam provides maximum protection for the back of the board.
When adjusting the width of the cover, an extra thickness of foam folds to the sides and provides up to 1.5 cm of extra protection, to take care of the board's rails which are often damaged during transport.
The sleeve is adjustable thanks to a lacing system that allows you to adjust the size of the sleeve precisely to the shape of the board.
At the back, the excess component folds up on itself, rolls up and gets stuck into place by the 2 tightening straps that secure the windsurfing board.
A pouch has been provided on the top of the cover to constantly keep the fin close to the board. It is closed by a scratch securing the contents.
This cover accepts the vast majority of windsurfing boards on the market and therefore adapts to all volumes and shapes within the limits mentioned below:
- length between 2.35 m and 2.70 m.
- width between 60 and 90 cm.
Tips for storage and maintenance
MAXIMUM WASH TEMPERATURE 95°C. NORMAL TREATMENT.
MAXIMUM WASH TEMPERATURE OF 30°C. VERY MODERATE TREATMENT.
IRON AT A MAXIMUM SOLEPLATE TEMPERATURE OF 150°C.
MAXIMUM WASH TEMPERATURE 70°C. NORMAL TREATMENT.
IRONING AT A MAXIMUM IRON SOLEPLATE TEMPERATURE OF 200°C.
It is advisable to rinse well, drain the water as much as possible and dry the cover as well as the board it protects before reinserting the board.
Restrictions on use
This cover is not specifically designed for air freight