DREAMSCAPE
Ref.
8642872
4276847
Wide anti-slip snowboard pad
€13.00
Tax included
Store Availability
Store Availability
This pad was developed to prevent the foot from slipping on the snowboard, especially when taking a ski lift.
BENEFITS
Anatomic design
Stick the 4 pads as you want to adapt it to your sole.Compact design
Dimensions: 16.5 x 10 x 0.55 cm. It comes in 4 parts so you can make it biggerTraction
Wide structured surface for maximum boot grip on the pad.Grip
Wide surface and 3M Scotch tape for a good bond between the pad and the board.TECHNICAL INFORMATIONS
Advice on gluing the pad to the board
Absolutely make sure that you spend 4 minutes sticking the pad down properly.
1. Before gluing, clean the board well with a damp sponge and soap or dish soap to degrease it.
2. Rinse thoroughly to remove any soap.
3. Dry with a cloth.
4. Stick the pads where you want them, near the rear binding.
1. Before gluing, clean the board well with a damp sponge and soap or dish soap to degrease it.
2. Rinse thoroughly to remove any soap.
3. Dry with a cloth.
4. Stick the pads where you want them, near the rear binding.
Choice of the position of the pads
Place the 4 pads where you will put your foot when you take the chairlift. Before gluing, think about simulating a chairlift ride to find the area where your back foot is to be positioned. Warning! Do not glue the pads within 4 cm of the screw inserts, otherwise you will no longer benefit from the maximum setting of the bindings.
composition
composition
Bed base: 100.0% Ethylene Vinyl Acetate
Tips for storage and maintenance
DRYING IN A TUMBLE DRYER POSSIBLE. NORMAL TEMPERATURE, MAXIMUM EXHAUST AIR TEMPERATURE OF THE DRUM 80°C.
MAXIMUM WASH TEMPERATURE OF 30°C. VERY MODERATE TREATMENT.
IRON AT A MAXIMUM SOLEPLATE TEMPERATURE OF 150°C.
MAXIMUM WASH TEMPERATURE 70°C. NORMAL TREATMENT.
IRONING AT A MAXIMUM IRON SOLEPLATE TEMPERATURE OF 200°C.
TESTS AND WARRANTY
Warranty
2 Years