Product Description
Overview
SCV Clik Valve
The new standard in bike valves. Schwalbe Clik Valves have been designed to eradicate all of the problems and complications that come with inflating tyres using Presta Valves. It can be operated with just one hand and is suitable for everyone.
**Clik Valve ### Features
- The valve insert and compatible pump head or adapter make inflation quick and effortless.
- No air loss and no wear on the pump head.
- Backwards compatible: can still be inflated with standard SV (Presta) pumps.
- Can be operated with just two fingers - easy for everyone.
- Offers 50% more airflow when used with tubeless systems compared to regular SV valves.
Aerothan Tubes
Aerothan is a material that completely redefines the bicycle tube: extremely light, highly puncture-resistant, and designed for the lowest rolling resistance.
Aerothan tubes are about 40% lighter compared to Schwalbe Extralight tubes made of butyl. In addition to an extremely low rolling resistance at tubeless levels and has increased puncture protection.
Aerothan tubes consist of 100% thermoplastic polyurethane (TPU), including the valve, and are therefore fully recyclable. Like all Schwalbe tubes, Aerothan tubes may be returned to Schwalbe at no cost using the tube recycling program. The material of used tubes is recycled to make sealing or insulation material.
Aerothan Advantages
- Extremely heat resistant
- Offers a stable ride even at low air pressures
- Minimal rolling resistance - maximum driving dynamics
- Easy mounting without slipping or jamming
- Consistently light
- 100% Recyclable
- Made in Germany
Repair and tyre pressure
- Use Schwalbe Glueless Patch, classic patches do not stick to the TPU material.
- No roughening required
- Do not use puncture sprays
- Do not use chemical cleaners
- Tire pressure can be based on the recommendations for a tubeless system
- Minimum pressures engraved on the Schwalbe tires are correct according to butyl tubes. These values can be undercut when using Aerothan
- Check the maximum rim pressure, if it is lower than the maximum tire pressure
Intallation
- When inflating the Aerothan tube outside the tire, it should not be inflated to more than 0.3 bar
- Avoid over-inflation and over-rapid inflation outside the tire, as the material expands with a delay.
- Inflating too quickly can lead to bubbles forming on the Aerothan tube the tube can then no longer be used
- Inflation with CO2 cartridge is only recommended when fully installed
- Re-installation is possible with the same or larger tire width (Note size information on the packaging)
- When converting from Tubesless to Aerothan: Thoroughly clean tire and rim and remove residues of sealing milk
- Aerothan tubes are compatible with rim tapes
