HAND WARMER X10
Store Availability
These hand warmers offer you regular gentle warmth for 5 to 6 hours, for greater comfort during your winter activities.
Activated upon contact with the air for regular gentle warmth that lasts 5 to 6 hours. Designed to neatly fit inside your gloves, giving you comfort when you need it most.
BENEFITS
Warmth
To get started, they need oxygen and humidity.
Long-lasting effect
Diffusion of a soft heat for at least 5 to 6 hours. Single-use product.
Ease of use
Blow on them to speed up the start, especially at 0°C or over 2,000 m
Fast acting
Open the bag / shake / wait 10 min. Ideally activate at room temperature.
Instructions
DownloadTECHNICAL INFORMATIONS
Instructions/Heating
1. Remove the warmer from the package and shake it 5-6 times to activate the heating process.
2. Wait for 10 minutes since the WARMER MUST BE FULLY WARM before being put in a confined space (pocket, glove, etc.).
3. Ideally, activate them in an ambient environment of 20°C (at home, in the car, etc.).
4. At 0°C or above 2,000 m altitude, blow on them several times. The warmth and moisture of your breath will accelerate the start of the reaction.
HOW IT WORKS
A warmer is a mix of active charcoal powder and iron which produces heat by oxidizing the iron.
The reaction is stopping:
_When there is no more active charcoal. It stops completely after about 5 to 6 hours.
_In an airtight space (in a rubber boot or with neoprene cycling overshoes).
If you add air to the warmer, the reaction starts.
Restrictions
HAND warmers should only be used for your hands and should not be used on other parts of the body
Precautions
Children, the elderly and disabled people should use this product with care and under supervision.
Seek the advice of a doctor before use in cases of diabetes, delicate or sensitive skin, blood circulation problems, paralysis or damaged nerves, rheumatoid arthritis, if you are pregnant or if you have any doubt.
Do not apply to frostbite or desensitised skin. Do not use while sleeping.
Do not use at the same time as external analgesics or other heating devices.
Good to know
The exothermic reaction begins on the production line:
_ The mix is activated then checked at 100%
_ Once inspected and validated, the pair of hand warmers is inserted in the plastic packet which stops the reaction and therefore the heat generation. It will start again when the pack is opened with oxygen and humidity.
WHAT SHOULD I DO IF MY WARMER STOPS HEATING AFTER 1 HOUR? OR IF IT DOESN'T HEAT ENOUGH?
This means that the reaction is suppressed by lack of air. Just remove the warmer, give it air, knead it or blow on it to begin the heating process again. You can then put it back in your glove or pocket.
BORDERLINE CASES
The warmer is not working:
_ If there isn’t enough air around the warmer : enclosed in neoprene for example.
_ If conditions are extreme: in extreme cold, the warmer provides additional warmth to the operating temperature, but unfortunately it struggles to warm up if the temperature really is too low.
_ If the altitude exceeds 3,000 m, the lack of oxygen reduces the reaction.
Single-use product.
The exothermic reaction consumes the activated charcoal and oxidises the iron. Once the fuel is consumed, the reaction is complete and the powder becomes hard.
composition
composition
Formula: 15.0% Activated Carbon, 3.0% Salts, 9.0% Vermiculite, 18.0% Water, 55.0% Iron
Tips for storage and maintenance
Storage tips
Store in a cool, dry place away from direct sunlight.
Restrictions on use
Not to be used for children under 3 years of age.
TESTS AND WARRANTY
Warranty
2 Years