Skip to main content
🚚 Selected Free Delivery for Orders Over €200 📦
New Lower Price

DECATHLON

Men's waterproof and windproof sailing jacket, 100 blue red

4.7 out of 5 stars from 6645 reviews
6645 reviews

This men’s waterproof jacket is designed for inshore sailing in wet, stormy and windy conditions.

This men’s waterproof sailing jacket is designed for inshore sailing in rainy or windy conditions. Lightweight and breathable, it has a high collar and withstands moderate rain for up to two hours.

ID 8678295

€30.00 Was €32.00
Tax included
Colour: Blue / Red

  • Pick up at Decathlon

    loading…

  • Pick up near you

    loading…

  • Home Delivery

    loading…

Design benefits

  • water repellent

    Especially treated so water slides off the fabric surface.

  • abrasion resistance

    Friction-resistant weave 20,000 cycles

  • windproof

    Fabric specially coated to reduce the cooling effect of the wind.

  • waterproof

    100% taped seams 2-layer coating 5,000 mm Schmerber

  • pockets

    3 closed pockets, 1 interior Non-waterproof pockets

  • breathability

    Breathable coated fabric (RET < 12): reduces condensation 10,000 mm (g/m²/24hrs)

  • Features

    Design details

    The water resistance level

    We measure the fabric resistance to water pressure in mm of water column (based on the JIS standard). The higher the water pressure withstood by the fabric, the more waterproof it is.
    On our Sailing 100 jacket:
    Component is resistant to water pressure of 5,000 mm Schmerber (JIS standard). This equates to the average pressure applied by the water during a rain shower.
    The anorak’s waterproofness was tested in a rain shower with 60 litres of water/m²/hour for 2 hours.

    Jacket waterproofing

    - High collar
    - Injection-moulded plastic to avoid salt oxidation
    - Water-repellent components (water runs off the fabric)
    - 100% taped seams
    - Central opening features a flap with a drainage channel for optimal waterproofing

    Hood

    The hood does not pack down into the collar, it is attached.
    Completely depth and height-adjustable hood.
    Visor with a headband to provide a good level of protection and a better hold.
    The high neck effectively protects the neck.

    Pockets

    2 zip pockets on the front of the jacket to put your hands or some items
    1 inside pocket on the right side of the chest with a rip-tab closing

    The pockets are not waterproof!

    Front zip closure

    A zip on the entire jacket length with an interior flap protects against the wind and water.
    Soft fabric flap on the top of the collar to protect the chin.

    Fabric breathability

    To find out whether a fabric is breathable, we test its evaporate resistance or RET (ISO 11092 standard). The lower the fabric’s resistance, the more moisture is evaporated, and therefore the higher the fabric’s breathability.
    We consider that if:
    RET < 9 = highly breathable fabric
    9 < RET < 12 = breathable fabric
    The RET of the Sailing jacket 100 is 12.

    Water-repellent properties information

    A fabric is water-repellent when water slides off the surface of the fabric, without seeping in.
    Your jacket does not become waterlogged and remains lightweight and breathable. The water-repellent properties are achieved with a treatment applied to the external side of the fabric, but in practice these properties can be altered.
    The water-repellent properties can be reactivated by putting the jacket in a dryer for 10 minutes at the lowest temperature.

    How to wash your jacket

    To maintain the water repellent properties, infrequent washing is recommended.
    Close all zips and flaps, empty all pockets and then turn the garment inside out to wash it. You can wash it on a synthetic cycle at 30°C or 40°C with your usual detergent. Do not use fabric conditioner, which could damage the existing performance of the garment, or bleach. Very important: choose a full rinse cycle or extra rinse.

    How to reactivate the jacket’s water repellency

    Drying is a crucial phase in reactivating the water repellent treatment.
    We recommend that you lay your jacket flat on a clothes rack and leave it out to dry in the open. The radiator? Forget it!
    Then place them in the tumble dryer on a short synthetics cycle, i.e. 10 to 15 minutes, before turning it back the right way round. Caution: do not over-dry the garment.

  • Usage & care

    Warranty

    2 Years

    Care Instructions

    Cleaning

    • DO NOT DRY CLEAN.

    • DRYING IN TUMBLE DRYER POSSIBLE. LOW TEMPERATURE, MAXIMUM DRUM EXHAUST TEMPERATURE 60°C.

    • DO NOT IRON.

    • MAXIMUM WASHING TEMPERATURE 30°C. NORMAL TREATMENT.

    • BLEACHING EXCLUDED.

  • Specifications

    composition

    Upper part - Main fabric: 100.0% Polyamide;Lower part - Main fabric: 100.0% Polyamide;Main lining: 100.0% Polyester;Sleeve lining: 100.0% Polyester;Coating: 100.0% Polyurethane

  • Environmental impact

    With ecodesign, we reduce the environmental impact of our products.

    Analysing the product's environmental footprint enabled us to identify the most impactful stages of its life cycle. Thanks to this approach, our design teams were able to develop this product while significantly reducing its environmental impact.

    Learn more about our approach
    Environmental Impact

    Designed to reduce environmental impact

    Product made with a CO2eq reduction of 10% compared to the previous or similar product

    Read more

    Our design teams are working to develop processes that will reduce the impact of a product, while preserving its technical characteristics. This reduction relates to the following indicators: climate change, air pollution, water pollution and resource depletion.