INSPECTING THE ROPE:

It is important to check your rope regularly. To do so, run the rope through your hands and inspect it metre by metre along its entire length. This will allow you to spot any nicks, cuts, abrasion or weak points. If you notice any anomalies or irregularities, if the core is visible in certain places, if the rope or has exceeded its fall rating, it must be changed. Take safety seriously!

Long-life treatment:

Special treatment that increases the rope's lifespan and prevents water and dirt seepage.

Greater resistance to wear

Middle marking:

To improve your safety, this rope features a black mark which indicates the middle of the rope.

PLASMA TREATMENT:

Special treatment helps to improve rope's smoothness.

Stds/Certif.

EN 892:+A1: 2016

STORING THE ROPE:

Ropes should be stored in a cool, dry place, away from light, humidity, and corrosive agents. Never leave ropes inside a car during summer, for example.

TECHNICAL FEATURES:

NUMBER OF FALLS: 8/22

IMPACT FORCE: 6.6/10.1 KN

DYNAMIC ELONGATION: 26.2% / 23.8%

STATIC ELONGATION: 8.8% / 8.4%

SLIDING OF THE SHEATH: 0

NUMBER OF SPINDLES: 40

Ultrasound seal

Thanks to this new ultrasound fusion process, deterioration of rope ends is no longer an issue.

WASHING THE ROPE:

It's important to properly care for your rope to reduce wear.

As dirt wears ropes down, we recommend:

1- using a rope cover;

2- If the rope is dirty, wash it with clean, lukewarm water.

Should stains persist and you want to wash it with soap, it is important to use a pH-neutral soap (such as Marseilles/household soap) and then rinse thoroughly with clean water.

3- Air dry the rope out of the sun and away from all sources of heat.

Weight:

48 g/m



PLEASE NOTE: Weight measurements made according to the EN 892 standard.

For example, for a single rope, the rope must be exposed to 10 kg of tension for 1 minute in very precise temperature and moisture conditions.

This gives you the real weight of the rope, which is often superior to the weight given by the standard.

The weight measurement according to the standard is used to compare two ropes to each other.