Waterproof Sailing Shorts Tribord 900 - Light Grey
Store Availability
Store Availability
BENEFITS
Anatomic design
Adjustable belt thanks to a rip-tab around the hips
Water repellent
Water-repellent fabric stops water droplets from getting in and keeps you dry
Abrasion resistance
Reinforced backside for resistance to friction on the non-slip material.
Waterproof
The 3-layer fabric is highly waterproof
Pockets
4 pockets: a cargo pocket, zip pocket and 2 Italian pockets. Not waterproof
Breathability
The component provides a high level of breathability
TECHNICAL INFORMATIONS
WHY CHOOSE TRIBORD'S WATERPROOF SAILING SHORTS 900?
We recommend you wear waterproof shorts during your races or active cruising sessions, for all users wanting to maintain a dry backside. The waterproof component combined with the construction of the shorts guarantees no water ingress. You are protected when sitting on the wet boat deck or when hit by spray.
How are Tribord's Sailing Shorts 900 made waterproof?
The component combined with the construction guarantees a waterproof model.
The component is waterproof up to 10,000 mm schmerber, which gives it a high waterproofing level.
All the seams are taped to stay dry.
No seam is positioned on the buttocks to make the product robust and avoid water ingress on the part that comes into contact with the boat when you are sitting down
A water repellent treatment has been applied to the component so that water glides off the shorts
ARE THE SHORTS DURABLE?
We have added reinforcements to the backside so that the product is resistant to friction on the non-slip material of the boat deck.
We have chosen salt-resistant components with solid zips to last you a long time through all your adventures.
WHAT ARE ALL THESE POCKETS FOR?
This pocket features 4pockets:
- 2 hand pockets, cut to keep things in your pockets when sitting down
- zipped pocket on the left thigh, not waterproof, to keep a knife, etc.
- a cargo pocket with hook and loop flap on the right thigh and mesh at the bottom to allow water to drain out of the pocket.
THE SHORTS THAT ADAPT TO YOUR SIZE!
We have chosen to put a belt adjustable by a rip-tab on the hips so that the shorts fit your waist and so you can adjust them to how you like. The shorts remain firmly in place, without being too tight, for optimal comfort.
The press stud guarantees a safe fit and is much less likely to be snagged or caught than a conventional button during your manoeuvres. They perform well during your sailing adventures and are stylish!
DIVING SUIT WITH RACE LEGGINGS TRIBORD
These shorts have been designed to be worn with the RACE leggings to give the leggings better resistance to abrasion.
HOW TO WASH YOUR SHORTS:
To maintain the water repellent properties, infrequent washing is recommended.
Close all zips and flaps, empty all pockets and then turn the garment inside out to wash it. You can wash it on a synthetic cycle at 30°C or 40°C with your usual detergent. Do not use fabric conditioner, which could damage the existing performance of the garment, or bleach. Very important: choose a full-rinse cycle or extra rinse.
HOW TO REACTIVATE THE WATER REPELLENCY:
Drying is a crucial phase in reactivating the water repellent treatment.
We recommend that you lay your shorts flat on a clothes rack and leave it out to air-dry. Caution: never dry your shorts directly on a radiator.
Then place it in the tumble dryer on a short synthetics cycle, i.e. 10 to 15 minutes, before turning it back the right way round. The heat reactivates the water-repellent treatment.
Caution: do not over-dry the garment.
composition
composition
Main fabric: 100.0% Polyester; Yoke: 2.0% Elastane, 37.0% Polyamide, 61.0% Polyester; Pocket: 100.0% Polyester; Membrane: 100.0% Polyurethane
Tips for storage and maintenance
MAXIMUM WASH TEMPERATURE OF 30°C. VERY MODERATE TREATMENT.
BLEACHING EXCLUDED.
DRYING IN TUMBLE DRYER POSSIBLE. LOW TEMPERATURE, MAXIMUM DRUM EXHAUST TEMPERATURE 60°C.
DO NOT IRON.
DO NOT DRY CLEAN.
Storage tips
Rinse your shorts and store them in a dry and well-ventilated place.
TESTS AND WARRANTY
Warranty
2 Years
Agree by
Jean-Baptiste Daramy offshore racer in Class 40 and Romain Le Gall & Léo Bothorel Mini 6.50 racers.
Our Ecodesign Approach
Our ecodesign approach reduces the environmental impact of our products.
We’ve examined the environmental footprint of this product in order to identify how we can produce it in a more sustainable way. With this knowledge, our design teams were able to develop this product while significantly reducing its environmental impact.
Sustainable design measures implemented on this product.
-
MaterialRecycled polyester
Product made from 80% recycled polyester
Using recycled polyester rather than conventional polyester reduces the CO2 emissions linked to the material by at least 17%.